Pentens Latex-108 is an one-component, acrylic based liquid resin, mix with normal Portland cement or white cement, used as flexible adhesive, patching mortar, base coat and the water-resistant.

Pentens Latex-108 can only apply to sound, clean, dry, well prepared, frost-free surfaces. After mixing with cement, it may be used:
– As a base coat for floor screeds
– As a flexible adhesive for tiling, glazing,
– As a patching mortar, concrete repair mortars
– As a abrasion resistant linings

– Easy to use, only mix with cement on the job site
– Excellent adhesion and durability
– Crack resistance
– Good flexural strength
– Good impact strength
– Freeze-thaw resistance
– Vapor permeable
– Low alkalinity
– Excellent water resistance

Total Volatile Organic Compounds – Non-detected
Total Aldehydes – Non-detected
Formaldehyde – Non-detected
4-phenylcyclohexene – Non-detected
Phthalates – Non-detected
Alkylphenolethoxylates – Non-detected
Halogenated Solvents – Non-detected

Substrates: All substrate surfaces must be clean, free from grease, oil, laitance, dirts and contaminants which might affect adhesion. It is recommended to give substrate a rough or light-broom finish for better bonding strength.

Insulation board: Insulation board must be wellprotected, clean, dry and free from all bond-inhibiting materials and rasped if necessary before installation.

PENTENS LATEX 108 should be mixed thoroughly with normal Portland cement or white cement by using a low speed electrical or pneumatic power stirrer.

Mixing time is minimum 3-4 minutes until a homogeneous mix is achieved.

Mixing Ratio:
PENTENS LATEX 108 : 1
Cement : 1

Adjust mix if necessary by adding a small amount of clean water to achieve the desired texture finishing. Avoid re-tempering after mixing the product.

For Tile Adhesive (TA-Bond 888)
PENTENS LATEX 108 : 7L-8L
TA-BOND 888 : 25kg

Remove unhardened PENTENS LATEX 108 from tools and equipment with water immediately after use. Hardened material can only be removed mechanically.

Wear rubber gloves and goggles when using the material. If the material gets into the eyes, rinse immediately with clean water and seek medical treatment if irritation persists.